DCC Decoder tester
Our SKU: 4221-9533Regular price £24.95 Save £-24.95
GAUGE: 0, 00, N,
Our DCC decoder tester will allow you to test decoders before fitting them to your loco's
Tests all 6, 8 and 21 pin decoders up to 6 functions as well as hardwired decoders too!
Works with any type of DCC controller, simply plug your decoder into the tester, then connect the tester to the track and operate as normal.
Clear LED indicators show functions, lights as well as direction and track power.
Never waste time fitting a faulty decoder again!
Gaugemaster Ruby series PowerPal for use with DCC90/91/94/95
Our SKU: 9087-6534Regular price £16.95 Save £-16.95
GAUGE: 0, 00, N,
The DCC99 is the PowerPal stay alive capacitor and is designed to keep your locomotives running through dirty or dead track sections. Once a bad bit of track is detected the capacitors kick in and keep the motion, lights and sounds alive until power is restored. The time period can change depending on the decoder that the PowerPal is fitted to.
Gaugemaster Ruby DCC decoder 21 pin DCC91
Our SKU: 9734-2144Regular price £16.95 Save £-16.95
GAUGE: 0, 00, N,
The DCC91 is a direct plug 21 pin decoder. Fitted in the decoder is a small 2 pin socket which can have the PowerPal inserted into it (sold seperately), This helps keep the locomotive moving in dirty or dead track sections.
|NO. OF PINS||21|
|NO. OF FUNCTIONS||2|
|SPEED STEPS||14, 28 or 128|
|MOTOR CURRENT RATING||1.5A - 2.0A Max|
Hornby R8213 DCC Select Controller
Our SKU: 8164-9832Regular price £106.00 Sale price £98.00 Save £8.00
Gaugemaster DCC40 auto-reverse loop module
Our SKU: 5343-0113Regular price £38.00 Save £-38.00
Automatically switches polarity in a reverse-loop situation - completely hands free. This unit can be used in a variety of different ways from simple reverse loops to complicated triangles. Ideal for DCC layouts.
Also works with turntables. Full instructions supplied.
Cable length 100mm
Hornby R8242 *USED*
Our SKU: 0243-4323-SHRegular price £2.00 Save £-2.00
A power clip suitable for DCC use.
Brand new but without original packaging.
R8247 Points and accessory decoder
Our SKU: 4233-0511Regular price £42.50 Save £-42.50
Being able to change points and operate accessories with the minimum of wiring and fuss is one of the main attractions of digital control and the Hornby Accessory and Point Decoder allows the operator to do just that.
Wiring points up in the old analogue fashion can be quite a daunting exercise. On some layouts which have numerous points this can mean that there are meters upon meters of cabling plus a whole bank of switches. Hours can be spent carefully wiring up the points only to find that there is a fault or an intermittent connection which means more hours of crawling about on the floor trying to locate the problem. With the Hornby digital system these horrors can be but a distant memory.
The Hornby R8247 Accessory/Point Decoder can be programmed to accommodate four point motors or solenoid operated accessories, plus other electrical accessories that require a constant or delayed current flow, for example a turntable.
Connection of the points or accessories to the Hornby Accessory/Point Decoder is straightforward. The four outputs are factory set for the operation of solenoid (point) motors, however, by adjusting the CV settings of each output a graduation of varying "bursts" of current up to a constant current (turntable motor operation, lighting, etc.) can be obtained for each individual output.